You ll want to use a medium heat setting and hold the gun about 2 inches from the crease.
Ising a hair dryer to get our wtinklr in vinyl.
Don t get the hair dryer too hot or too close to the tablecloth or you run the risk of melting a hole in it.
If you are in a situation where you must use either a hair dryer or an iron like if you need to use the vinyl in a short period of time and it s raining outside there are some cautionary steps you can take to make sure your vinyl is protected.
Before hanging an old banner smooth out any wrinkles by placing it out in the sun.
How to get wrinkles out of vinyl using an iron or hair dryer.
2 sided blockout banners.
Put the hair dryer on high and aim it at the wrinkles.
You re slowly heating up the material so that it works out the wrinkles on the surface.
I had a french braid put in my hair.
You can also use a hair dryer an iron or a hot wet cloth to do the same.
Use a hair dryer on a low setting to get the wrinkles out.
Keeping your vinyl banner clean.
Let the straightened screen cool completely before.
Because you will need to hold the hair dryer close to the window tint you may need to use an extension cord to make sure that it will reach.
Pass the hot air back and forth over the tablecloth and smooth it with your hand.
The vinyl banners are great tools for large format advertising but they are prone to wrinkles.
Use a hair dryer.
This technique is especially helpful if you have an extra set of hands to gently pull the.
A warm dryer will get wrinkles out of vinyl tablecloths.
Use the low setting on your hair dryer and avoid pointing it at the printed side of the material.
However once it gets wet use the iron on medium to steam iron stubborn wrinkles out and the banner will be good as new once again.
Let the natural weight of the screen pull the softened vinyl into place.
The hair dryer method works on a similar principle.
The heat will do wonders for this.
I knew i wouldn t be combing or washing my hair for a few days.
When the nurse came to take me.
Plug your hair dryer into a power source.